Tom:
I am not a professor of anything..I build big commercial towers for a
living...and the odd Ham job on the side..
What we are talking about here is guy radius...distance from the tower base to
the guy anchor point...
The manufacturer's prints are normally done for flat gound...
General rule of thumb for uneven round....
a. for every foot anchor is above tower base move anchor back/away from tower a
foot
b. for every foot anchor point below tower base move anchor in a foot....
Maybe the professor is from Giligans Island?
Doug
VE6PR
>------- Original Message Follows -------
>From: "Tommy Alderman" <aldermant@windstream.net>
>To: "'Tower and HF antenna construction topics.'"<towertalk@contesting.com>
>Subject: Re: [TowerTalk] Digging holes for anchor rods
>Date: Mon, 26 Apr 2010 20:28:26 -0400
>
>Thanks Michael!
>
>I'm not sure if you have unlevel ground, how you would make the top of all
>three holes level. But no problem as I have two respected references and I
>am not going to bother with getting the bottom of the anchor holes the same
>level.
>
>Thanks to all,
>
>Tom - W4BQF
>
>
>
>-----Original Message-----
>From: towertalk-bounces@contesting.com
>[mailto:towertalk-bounces@contesting.com] On Behalf Of Michael Goins
>Sent: Monday, April 26, 2010 8:22 PM
>To: Tower and HF antenna construction topics.
>Subject: Re: [TowerTalk] Digging holes for anchor rods
>
>No. Make sure the TOP is level and all will be fine.
>
>Michael Goins, k5wmg
>Professor, Writing
>University of Texas at San Antonio
>
>
>
>
>
>
>
>On Mon, Apr 26, 2010 at 6:32 PM, Tommy Alderman
><aldermant@windstream.net> wrote:
>>
>>
>> It has been posed to me by a local commercial construction supervisor,
>that
>> I use a laser leveler to make sure the bottom of the anchor rod holes are
>at
>> the same level. While I have great faith of this persons word (based on
>the
>> experience he has on the job.), I have never heard of any ham going to
>these
>> lengths. My tower site ground does not change drastically, possibly a foot
>> difference from the other two holes.
>>
>>
>>
>> In you tower builders opinion, do you think this is a necessary step? Did
>> you do it when installing your own tower?
>>
>>
>>
>> Many thanks for any input.
>>
>>
>>
>> 73,
>>
>>
>>
>> Tom - W4BQF
>>
>>
>>
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|