On 8/26/05 at 1:15 PM R.Measures wrote:
>On Aug 26, 2005, at 8:18 AM, Will Matney wrote:
>
>>
>>
>> *********** REPLY SEPARATOR ***********
>>
>> On 8/26/05 at 3:41 AM R.Measures wrote:
>>
>>> On Aug 25, 2005, at 9:33 PM, KD7QAE wrote:
>>>
>>>> So, many of the plate chokes I have seen described in home brew
>>>> amplifiers and those in use in Ameritron, Henry, Alpha and QRO are
>>>> single layer wound solenoids, many like the one I built. These do
>>>> not
>>>> exhibit resonant peaks (High Z) in the ham bands as far as I can tell
>>>> based on my limited experience.
>>>
>>> A single-layer choke of up to c. 60uH will exhibit no resonances below
>>> approximately 35MHz, however, larger chokes will.
>>
>>
>> Not in the normal ham bands I doubt it.
>
>I measured such chokes and I did not find any resonances below about
>35MHz. .
>
>> I have seen them though, well lets say in other places close. However
>> a choke for that frequency
These were Ohmite Z-14 (The orange ones) chokes that I recall and had a RS
around 23 MHz.
>
>Which frequency?
They were used at 27 MHz but found the SR at 23 MHz with a dip meter.
>...
>Richard L. Measures, AG6K, 805.386.3734. www.somis.org
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|