I too am puzzled. The manuals that I have received from Tentec with the
equipment that I purchased has a written circuit description, a schematic,
and a component layout. And where appropriate, a written alignment
procedure.
If you don't have a manual, they are available for purchase from Tentec.
When I sold my equipment, also supplied, to the buyer, the manual that came
with the equipment. It often contained my pencil notes, thus they can be
easily erased, and figures from my operational or alignment notes or
performance data.
What's missing?
73
Bob,. K4TAX
----- Original Message -----
From: "John Cox" <jecox@tri-lakes.net>
To: <wb2vuf@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Saturday, December 29, 2007 10:03 AM
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
>I have an Omni 6 and an Omni 6+ and the manuals seem to be pretty detailed
> to me. Most of the manual is devoted to descriptions of componets and
> service information.
> What is it that I am missing here? I would think that with the
> information
> supplied that any person with an electronics back ground could service
> them.
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|