Re: [TenTec] OMNI6 PLUS Alignment procedure needed

["John Cox" <jecox@tri-lakes.net>]

Ken
I agree.  I may have been confusing my Omni manual with my Drake TR4CW 
manual.
They are both out in my barn shack.  Its to cold to go out and check.  I am 
still trying to talk my wife into letting me move it into the house.
73
John KC0YAI


----- Original Message ----- 
From: "Ken Brown" <ken.d.brown@hawaiiantel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, December 29, 2007 5:53 PM
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed


> Hi John,
>
> The information needed to perform a complete alignment of an Omni VI may
> in fact be contained in the manual. However it is not all in one place
> and listed in the most efficient order. Each of the circuit boards has a
> text description of how the circuits are supposed to work, and in most
> cases how to adjust them. A start to finish list of adjustments, in the
> best order to do them, for the whole radio, not just individual boards,
> would be nice.
>
> DE N6KB
>
>
> > I have an Omni 6 and an Omni 6+ and the manuals seem to be pretty 
> > detailed
> > to me.  Most of the manual is devoted to descriptions of componets and
> > service information.
> > What is it that I am missing here?  I would think that with the 
> > information
> > supplied that any person with an electronics back ground could service 
> > them.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec