I think K1TTT did exactly that to verify patterns on his stacks...it was pretty
interesting. His report is probably up on his website somewhere.
73, Ken N2ZN
> On Sep 4, 2021, at 9:29 PM, Lux, Jim <jim@luxfamily.com> wrote:
>
> On 9/4/21 5:19 PM, Mike Smith VE9AA wrote:
>> GE Stan,
>>
>> I have absolutely no hard engineering facts for you, other than to say that
>> when I installed my 4-squares a few years ago, I located a small signal
>> source about 200' away from all the arrays and made RX measurements with the
>> arrays and my IC-7410. I seemed to have very good results at this 200'
>> distance from a vertical and a bunch of my 4-squares.
>>
>> I would've rather had 300' or 400', or even 700' but that would've meant
>> locating my signal source on someone else's land and I didn't want to do
>> that, for various reasons. (bringing attention to my hobby as one reason)
>>
>> I posted results here, if it's worth anything to you.
>>
>> Re: [TowerTalk] Wire 4-squares - they work ! (long) (GAIN?) (contesting.com)
>> <http://lists.contesting.com/archives/html/Towertalk/2016-10/msg00213.html>
>>
>>
>> GL and thanks for all the contest Q's !
>>
>>
>> Mike VE9AA
>
>
> These days, putting a source on a UAV would be super practical.. And getting
> 1000 ft away would be easy.
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|