Tom Rauch, W8JI has a nice webpage dedicated to the MFJ-1025/1026 at
https://www.w8ji.com/mfj-1025_1026.htm.
A few relevant excerpts follow.
"The only drawback of the higher noise floor of the MFJ-1025/1026 is you *must
place it after any amplifiers used with low-level low-noise antennas*. The
MFJ-1025/1026 noise floor is typically around 14dB."
"The MFJ1025 series, despite being manufactured as inexpensively as
possible, outperforms any other unit I have tested (by a large margin) over
its intended *frequency range of 1.8-20 MHz*. The exception is the DX
Engineering NCC-1..."
That being the case, shouldn't noise tests be done on 160 or 80 meters,
rather than 10 or 15 meters?
73, Mike
W0BTU
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|