Re: [TenTec] Omni VI+

[Malcolm McLeman <f5vbu@cegetel.net>]

The diodes re available on the open market though the type numbers on 
the board differ from the O-6 manual .. Malc
the board differ from the Omni VI cct diagram. Malc

On 4/4/2018 3:52 PM, MadScientist1948 wrote:
> If those are bad, I have some in one of my spare Omni 6 boards.
>
> Gary
>
> > On Apr 3, 2018, at 11:57 PM, Malcolm McLeman <f5vbu@cegetel.net> wrote:
> >
> > Worst scenario is the T/R switching diodes on the BPF board.
> > Take the top cover off then the speaker bracket at the back. Release coax lead 
> > 17 right hand back and inject a sig from antenna on there. 73 Malc F5VBU
> >
> > On 4/3/2018 4:07 PM, Paul DeWitte wrote:
> > > Good morning all, turned on my Omni VI+ this morning and I have no
> > > receive audio of rf signals.
> > > What I do have is atmospheric noise on all bands but no signals either
> > > SSB or CW.
> > >
> > > I have tried master reset twice. Checked for loose connections inside
> > > with no luck.
> > >
> > > I do have TX output.
> > >
> > > Corsair II on same antennas work fine.
> > >
> > > Any suggestions?
> > >
> > > Thannks,73
> > > Paul K9OT
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec