Worst scenario is the T/R switching diodes on the BPF board.
Take the top cover off then the speaker bracket at the back. Release
coax lead 17 right hand back and inject a sig from antenna on there. 73
Malc F5VBU
On 4/3/2018 4:07 PM, Paul DeWitte wrote:
Good morning all, turned on my Omni VI+ this morning and I have no
receive audio of rf signals.
What I do have is atmospheric noise on all bands but no signals either
SSB or CW.
I have tried master reset twice. Checked for loose connections inside
with no luck.
I do have TX output.
Corsair II on same antennas work fine.
Any suggestions?
Thannks,73
Paul K9OT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|