If those are bad, I have some in one of my spare Omni 6 boards.
Gary
> On Apr 3, 2018, at 11:57 PM, Malcolm McLeman <f5vbu@cegetel.net> wrote:
>
> Worst scenario is the T/R switching diodes on the BPF board.
> Take the top cover off then the speaker bracket at the back. Release coax
> lead 17 right hand back and inject a sig from antenna on there. 73 Malc F5VBU
>
> On 4/3/2018 4:07 PM, Paul DeWitte wrote:
>> Good morning all, turned on my Omni VI+ this morning and I have no
>> receive audio of rf signals.
>> What I do have is atmospheric noise on all bands but no signals either
>> SSB or CW.
>>
>> I have tried master reset twice. Checked for loose connections inside
>> with no luck.
>>
>> I do have TX output.
>>
>> Corsair II on same antennas work fine.
>>
>> Any suggestions?
>>
>> Thannks,73
>> Paul K9OT
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|