Paul
You can unplug the signal in and out of dsp on main board and touch them
together
See if it is getting through the dsp
I had that problem and it was the regulator supplying voltage to dsp chip.
Paul K0UYA
-----Original Message-----
From: Paul DeWitte
Sent: Tuesday, April 03, 2018 9:07 AM
To: tentec@contesting.com
Subject: [TenTec] Omni VI+
Good morning all, turned on my Omni VI+ this morning and I have no
receive audio of rf signals.
What I do have is atmospheric noise on all bands but no signals either
SSB or CW.
I have tried master reset twice. Checked for loose connections inside
with no luck.
I do have TX output.
Corsair II on same antennas work fine.
Any suggestions?
Thannks,73
Paul K9OT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|