TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] Eagle problem?

from [Jim Brown] [Permanent Link][Original]
To: tentec@contesting.com
Subject: Re: [TenTec] Eagle problem?
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 15 May 2014 22:26:11 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
On 5/15/2014 8:30 PM, Bob McGraw - K4TAX wrote:
And there is a MIC ground being pin #7 and a PTT ground being pin #5. They are different ground points internally. One is analog ground and one is digital ground. 

The cable shield MUST go to the CHASSIS to avoid the Pin One Problem.

73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] Eagle problem?, Jim Brown
Next by Date:  Re: [TenTec] Eagle problem?, Jim Brown
Previous by Thread:  Re: [TenTec] Eagle problem?, Bob McGraw - K4TAX
Next by Thread:  Re: [TenTec] Eagle problem?, Jim Brown
Indexes:  [Date] [Thread] [Top] [All Lists]