Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400

["Bob McGraw - K4TAX" <RMcGraw@Blomand.net>]

That's why I use N type connectors.  Much more likely to be water proof when 
installed correctly.  UHF connectors are inexpensive and not considered 
water proof.    Most commercial installations will use N type connectors for 
waterproof reasons and constant impedance reasons.  Of course they are more 
expensive.
I see a N connector on the line at the house, N connector on the line at the 
top of the tower.  Then  N connector with a piece of RG-213 on one end and a 
UHF on the other because that's what the balun uses.  That the maximum 
number of connectors exposed.  No adaptors required.
I have 6 runs of LDF4-50 configured this way and up the tower at the house. 
The 100 ft repeater tower as 12 runs of LDF4-50 with an antenna on each one.
73
Bob, K4TAX







----- Original Message ----- 
From: "Mike Wetzel" <mjwetzel@comcast.net>
To: "'Craig Thompson'" <craig@thompsonet.com>; "'GARY HUBER'" 
<glhuber@msn.com>
Cc: "'SMC'" <smc@w9smc.com>; "'TenTec Reflector'" <tentec@contesting.com>; 
"'W9AML group-email'" <w9aml@midlandsnetworking.com>; 
<DX-IS@yahoogroups.com>
Sent: Wednesday, April 24, 2013 12:07 PM
Subject: Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400


> I would also agree with Craig.
>
> There are more possible failure points with the connections but really not
> loss.  If there was loss the connectors would heat up which they really
> don't.  Imagine how hot it would be if you were running RTTY at full power
> and you had just .1 db loss at a connector in a sealed connection.
>
> Mike W9RE
>
> -----Original Message-----
> From: SMC [mailto:smc-bounces@w9smc.com] On Behalf Of Craig Thompson
> Sent: April 24, 2013 12:53 PM
> To: GARY HUBER
> Cc: SMC; TenTec Reflector; W9AML group-email; DX-IS@yahoogroups.com
> Subject: Re: [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400
>
> Hi Gary
>
> I would use the 1/2" Heliax. I use both and the outer jacket of the Heliax
> is superior to the LMR for both water and sun. It also has lower loss. I
> would use LMR400 UF or similar for the rotator loop. Use all UHF 
> connectors
> for connections.
>
> 73, Craig K9CT
>
>
> On Wed, Apr 24, 2013 at 11:37 AM, GARY HUBER <glhuber@msn.com> wrote:
>
> >   As I consider the materials required to replace my 30 year old tower,
> > rotor, antenna and cables, I have several like new runs on LDF4-50A
> > terminated with N-male which could run from my ground window (UHF female)
> > to the top of my 53 foot tower (60 feet max LDF4-50A cable run)  where a
> > flexible low-loss 10 foot jumper would terminate on a new BN-4000 and new
> > TH-7 tribander.  This configuration would require the 60 feet max 
> > LDF4-50A
> > cable run,  two half inch N female to UHF male adapters, one UHF double
> > female and 10 feet of high quality RG8 cable as the jumper to the 
> > BN-4000.
> > The alternative which I'm leaning towards as it seems less likely to have
> > connector/adapter loss and other potential problems is a single run of 75
> > feet of LMR-400 with factory terminated PL-259s between the BN-4000 and
> > ground window UHF female termination. My current installation is 60 feet
> of
> > RG-9913, a UHF double female adapter and a ten foot RG-8214 jumper.
> >
> > I know the half inch Andrews Heliax has a much lower loss figure (0.357 
> > db
> > per 100 feet at 30MHz) for a given length versus the same length of LMR
> 400
> > (0.7 db per 100 feet at 30MHz) , but I'm thinking those three adapters
> (six
> > connection points for loss) and their potential problems make it a wash 
> > or
> > maybe the advantage goes to the 75 foot run of LMR-400.
> >
> > I'd be interested in any comments or experiences you might have on the
> > subject.
> >
> > 73 ES DX,
> > Gary -- AB9M
> +-----------------------------------------------------------------+
> SMC Web Site: http://www.w9smc.com
> List Help: http://mail.w9smc.com/mailman/listinfo/smc_w9smc.com
> Submissions: smc@w9smc.com   Problems? Contact: smc-owner@w9smc.com
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec