| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400 |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 26 Apr 2013 08:35:26 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On Fri, Apr 26, 2013 at 1:36 AM, GARY HUBER <glhuber@msn.com> wrote: > I read a piece about > coaxial cable shields with aluminum foil and braided copper, repeated > flexing, and moisture which destroys the aluminum and is a diode action > noise source. > If you're not using it for the rotor loop, I don't see why a coax run would be subjected to ANY, let alone repeated, flexing. Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400, GARY HUBER |
|---|---|
| Next by Date: | Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400, Phil Sussman |
| Previous by Thread: | Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400, GARY HUBER |
| Next by Thread: | Re: [TenTec] [SMC] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400, Phil Sussman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |