after all I have read on coaxial cable, I would choose the LMR-400. the
difference in signal loss at such a short run would not be noticeable to the
ear.
jack
ak7o
-----Original Message-----
From: GARY HUBER
Sent: Wednesday, April 24, 2013 10:37 AM
To: TenTec Reflector
Cc: SMC ; DX-IS@yahoogroups.com ; W9AML group-email
Subject: [TenTec] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400
As I consider the materials required to replace my 30 year old tower, rotor,
antenna and cables, I have several like new runs on LDF4-50A terminated with
N-male which could run from my ground window (UHF female) to the top of my
53 foot tower (60 feet max LDF4-50A cable run) where a flexible low-loss 10
foot jumper would terminate on a new BN-4000 and new TH-7 tribander. This
configuration would require the 60 feet max LDF4-50A cable run, two half
inch N female to UHF male adapters, one UHF double female and 10 feet of
high quality RG8 cable as the jumper to the BN-4000.
The alternative which I’m leaning towards as it seems less likely to have
connector/adapter loss and other potential problems is a single run of 75
feet of LMR-400 with factory terminated PL-259s between the BN-4000 and
ground window UHF female termination. My current installation is 60 feet of
RG-9913, a UHF double female adapter and a ten foot RG-8214 jumper.
I know the half inch Andrews Heliax has a much lower loss figure (0.357 db
per 100 feet at 30MHz) for a given length versus the same length of LMR 400
(0.7 db per 100 feet at 30MHz) , but I’m thinking those three adapters (six
connection points for loss) and their potential problems make it a wash or
maybe the advantage goes to the 75 foot run of LMR-400.
I’d be interested in any comments or experiences you might have on the
subject.
73 ES DX,
Gary -- AB9M
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|