My ideal OIII would include much of what has been discussed, but please make
it MARS compatible, and not just around the band edges.
I am a dedicated MARS member (with official orders) and operate on
restricted frequencies and licensed to operate in both Iraq and
Afghanistan. Without full MARS compatibility it is not in the realm of
consideration.
Thanks.
73
K4RFS
On Wed, May 18, 2011 at 1:50 PM, Frank Kirschner <KF6E@mail.com> wrote:
> Listen to the NR on the FTdx-5000. It can pull a signal out of the noise
> and make an unreadable signal readable, and a noisy signal armchair copy.
> This works on SSB as well as CW. I don't know what algorithm they're using,
> but it really works.
>
> 73,
> Frank
> KF6E
> ----- Original Message -----
> From: Carl Moreschi
> Sent: 05/14/11 11:37 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Orion III
>
> The NR you are talking about does not exist on any radio. Still to this
> day I have never seen an NR that truely helps with copy. They might make
> things quieter but copy is always best under difficult conditions with NR
> off. Carl Moreschi N4PY 121 Little Bell Dr. Hays, NC 28635 www.n4py.com On
> 5/14/2011 11:12 AM, Tony Lelieveld wrote: > Hi all, > > I agree. I'd go with
> an external panadapter. Why are people rumbling about > an Orion III? Let's
> get the O-II finalized first. I am still waiting for > an upgrade that will
> improve the NR part of the rig. One that, when you > activate it, will truly
> reduce the noise WITHOUT altering the audio quality > of the voice you're
> receiving. > > On some signals it seems to work okay but mostly it distorts
> the audio and > acts erratically and I am running ver. 2.044A. Different
> settings of the > AGC threshold and manual AGC level do not seem to make
> much difference. > > 73, Tony VE3DWI > > > ----- Original Message ----- >
> From: "Barry N1EU"<
> barry.n1eu@gmail.com> > To: "Discussion of Ten-Tec Equipment"<
> tentec@contesting.com> > Sent: Thursday, May 12, 2011 12:29 PM > Subject:
> Re: [TenTec] O3 wish list > > >> Well said and totally agree Paul. Limited
> engineering resources can >> be put to much better use. If the rig mfr
> provides I.F. output, >> they've done their job. >
> _______________________________________________ > TenTec mailing list >
> TenTec@contesting.com >
> http://lists.contesting.com/mailman/listinfo/tentec >
> _______________________________________________ TenTec mailing list
> TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|