My Orion III would be an Orion II with the addition of a sub-receiver
that is equal to the main receiver, a 9 mhz IF out jack, and receive
antenna out/back in loop connections so you could add devices such as a
noise cancelor in series with the receiver. It would also have 6 meters.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 5/18/2011 1:50 PM, Frank Kirschner wrote:
> Listen to the NR on the FTdx-5000. It can pull a signal out of the noise and
> make an unreadable signal readable, and a noisy signal armchair copy. This
> works on SSB as well as CW. I don't know what algorithm they're using, but it
> really works.
>
> 73,
> Frank
> KF6E
> ----- Original Message -----
> From: Carl Moreschi
> Sent: 05/14/11 11:37 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Orion III
>
> The NR you are talking about does not exist on any radio. Still to this day
> I have never seen an NR that truely helps with copy. They might make things
> quieter but copy is always best under difficult conditions with NR off. Carl
> Moreschi N4PY 121 Little Bell Dr. Hays, NC 28635 www.n4py.com On 5/14/2011
> 11:12 AM, Tony Lelieveld wrote:> Hi all,> > I agree. I'd go with an
> external panadapter. Why are people rumbling about> an Orion III? Let's get
> the O-II finalized first. I am still waiting for> an upgrade that will
> improve the NR part of the rig. One that, when you> activate it, will truly
> reduce the noise WITHOUT altering the audio quality> of the voice you're
> receiving.> > On some signals it seems to work okay but mostly it distorts
> the audio and> acts erratically and I am running ver. 2.044A. Different
> settings of the> AGC threshold and manual AGC level do not seem to make much
> difference.> > 73, Tony VE3DWI> > > ----- Original Message -----> From:
> "Bar
ry N1EU"<
> barry.n1eu@gmail.com> > To: "Discussion of Ten-Tec
> Equipment"<tentec@contesting.com> > Sent: Thursday, May 12, 2011 12:29 PM>
> Subject: Re: [TenTec] O3 wish list> > >> Well said and totally agree Paul.
> Limited engineering resources can>> be put to much better use. If the rig
> mfr provides I.F. output,>> they've done their job.>
> _______________________________________________> TenTec mailing list>
> TenTec@contesting.com> http://lists.contesting.com/mailman/listinfo/tentec>
> _______________________________________________ TenTec mailing list
> TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|