Let's do this one more time.......
TX EN on the Orion II should go to KEY IN on the Titan III
TX OUT (right below TX EN) on the Orion II should go to KEY OUT on the Titan
III
Keying Loop 1 in the menu should be enabled (assuming you used the #1
connectors on back of O II)
Amp Key Tracks in the menu should be Keying Loop
If this doesn't get it, there must be a relay problem in the O II or amp.
73 John W4II
----- Original Message -----
From: "John Molenda" <cdistflatfoot@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 8:21 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II
> Yes all connections seem good . John kb2huk
> ----- Original Message -----
> From: "Barry N1EU" <barry.n1eu@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, March 22, 2010 6:47 PM
> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>
>
>> On Mon, Mar 22, 2010 at 10:19 PM, John Molenda <brazos@rochester.rr.com>
>> wrote:
>>> I have reread the manual and looked at the hookup my question is this
>>> (when
>>> hooking Orion II to titan III amp ) there are only two cables to run
>>> between
>>> the two tx en out key in out . and then use the switch on the amp in qsk
>>> mode . then go to the tx menu and enable loop 1 . is this correct am I
>>> missing a hookup ? thanks John kb2huk
>>
>> Sounds right. Do you have the two cables correctly connected? Orion
>> TX Out 1 to amp Key In and amp Key Out to Orion TX EN 1 assuming
>> you're using Antenna 1 and have keying loop 1 enabled.
>>
>> 73,
>> Barry N1EU
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2764 - Release Date: 03/22/10
19:44:00
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|