I just check continuity of the two rca plugs and the coax it checks out good
. John kb2huk
----- Original Message -----
From: "John Molenda" <brazos@rochester.rr.com>
To: <ac5aa@ac5aa.com>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Monday, March 22, 2010 7:02 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II
> roger coax connected
> ----- Original Message -----
> From: "Duane Calvin" <ac5aa1@gmail.com>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Sent: Monday, March 22, 2010 6:51 PM
> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>
>
>> Oops - three cables - don't forget the exciter RF! :-)
>>
>> Duane Calvin, AC5AA
>> Austin, Texas
>> www.ac5aa.com
>>
>>
>> -----Original Message-----
>> From: tentec-bounces@contesting.com
>> [mailto:tentec-bounces@contesting.com]
>> On Behalf Of John
>> Sent: Monday, March 22, 2010 5:35 PM
>> To: Discussion of Ten-Tec Equipment
>> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>>
>> That is correct John!
>>
>> 73 John W4II
>> ----- Original Message -----
>> From: "John Molenda" <brazos@rochester.rr.com>
>> To: "aa4nn" <aa4nn@earthlink.net>; "Discussion of Ten-Tec Equipment"
>> <tentec@contesting.com>
>> Sent: Monday, March 22, 2010 5:19 PM
>> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>>
>>
>>>I have reread the manual and looked at the hookup my question is this
>>>(when
>>> hooking Orion II to titan III amp ) there are only two cables to run
>>> between
>>> the two tx en out key in out . and then use the switch on the amp in
>>> qsk
>>> mode . then go to the tx menu and enable loop 1 . is this correct am I
>>> missing a hookup ? thanks John kb2huk
>>> ----- Original Message -----
>>> From: "aa4nn" <aa4nn@earthlink.net>
>>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>>> Sent: Monday, March 22, 2010 9:14 AM
>>> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>>>
>>>
>>>> Does the term QSK or PTT ring a bell?
>>>> de Joe, aa4nn
>>>> Lake Wylie, SC
>>>> ------------------------------------------------------
>>>>>> Hello all , I am having a problem getting my Orion II to work with my
>>>>>> Titan III
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>> ----------------------------------------------------------------------------
>> ----
>>
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - www.avg.com
>> Version: 8.5.437 / Virus Database: 271.1.1/2763 - Release Date: 03/22/10
>> 07:33:00
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|