SORRY john....I'm losing it.
TX OUT on O II goes to KEY IN on Titan III
TX EN on O II goes to KEY OUT on the Titan III
There..........I've done that so many times I'm punchy!
73 John
----- Original Message -----
From: "John Molenda" <cdistflatfoot@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 8:23 PM
Subject: Re: [TenTec] Troubleshooting Titan 425 Problem
Holy cow ! everyone is having amp problems I am thinking it is al-Qaida
John kb2huk :>)
----- Original Message -----
From: "Art Trampler" <atrampler@att.net>
To: <tentec@contesting.com>
Sent: Monday, March 22, 2010 5:16 PM
Subject: [TenTec] Troubleshooting Titan 425 Problem
Hey Gang,
Today before work I turned on my Titan and went to the kitchen for a cup of
coffee. When I came back the amp was dead; its fuses are blown. I believe I
was gone for at least three minutes.
I am hoping it will burn out to be a problem with a filter capacitor or some
filter capacitors, but have this simple question:
Do I risk further damage to the unit and its tubes (if they are still good)
by replacing the fuses and turning it on, to see when the fuses blow/if
there are any other concurrent events, such as the it being ready to
operate, etc? If the failure is power supply related, I don't want to kill
the tubes inadvertently by this.
Thanks,
Art, KØRO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2764 - Release Date: 03/22/10
19:44:00
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|