OK... I was not reading the mail too closely. Sorry for the bandwidth.
Ralph Howes
W8BVH
----- Original Message -----
From: "gsanderlin" <gsanderlin@charter.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 8:03 PM
Subject: Re: [TenTec] Corsair II Vfo Molex Jumper
> Hi Ralph. I have the RCA phono jumper but not the molex one.
>
> -----Original Message-----
> From: W8BVH <w8bvh@sbcglobal.net>
> Sent: Sunday, March 21, 2010 17:14
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Subject: Re: [TenTec] Corsair II Vfo Molex Jumper
>
> gsanderlin:
> Why not just take a couple of rca plugs and wire the center pins only and
> use them. Pretty cheap.
> Best regards,
> Ralph Howes
> W8BVH
>
>
> ----- Original Message -----
> From: "gsanderlin" <gsanderlin@charter.net>
> To: <TenTec@contesting.com>
> Sent: Sunday, March 21, 2010 1:49 PM
> Subject: [TenTec] Corsair II Vfo Molex Jumper
>
>
>> Does anyone have A Molex Jumper for the Corsair II to allow it to work,
>> without the VFO connected, or know of the molex part number for the
>> housing and the pins.
>> _______________________________________________
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|