Thanks Ron , I am using the loop #1 and it worked good with my Titan 425 but
will not work with that setting and the III . I will give the amp keying a
try . john
----- Original Message -----
From: "Ron Castro" <ronc@sonic.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 12:18 AM
Subject: Re: [TenTec] having problem getting amp to work with Orion II
> John:
>
> Are you running with the keying 'loop' or just the standard amp keying?
> If
> you are using the loop, you have to turn on "Keying Loop 1" or "Keying
> Loop
> 2" and make sure you have the cables going from the OII to the Titan in
> the
> right places.
>
> If the loop system doesn't work, try the simple amp keying first. I don't
> know much about the Titan III, but it can't be too much different than the
> Titan 425.
>
> Ron N6IE
> www.N6IE.com
>
> ----- Original Message -----
> From: "John Molenda" <brazos@rochester.rr.com>
> To: "TEN TEC DISCUSSION" <tentec@contesting.com>
> Sent: Sunday, March 21, 2010 9:12 PM
> Subject: [TenTec] having problem getting amp to work with Orion II
>
>
>> Hello all , I am having a problem getting my Orion II to work with my
>> Titan III . can some one send me the menu settings I have to input
>> inorder to get the amp to work I think we have narrowed the problem down
>> to the Orion not being able to drive the amp . thaks John kb2huk
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|