Yes all connections seem good . John kb2huk
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 6:47 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II
> On Mon, Mar 22, 2010 at 10:19 PM, John Molenda <brazos@rochester.rr.com>
> wrote:
>> I have reread the manual and looked at the hookup my question is this
>> (when
>> hooking Orion II to titan III amp ) there are only two cables to run
>> between
>> the two tx en out key in out . and then use the switch on the amp in qsk
>> mode . then go to the tx menu and enable loop 1 . is this correct am I
>> missing a hookup ? thanks John kb2huk
>
> Sounds right. Do you have the two cables correctly connected? Orion
> TX Out 1 to amp Key In and amp Key Out to Orion TX EN 1 assuming
> you're using Antenna 1 and have keying loop 1 enabled.
>
> 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|