I have reread the manual and looked at the hookup my question is this (when
hooking Orion II to titan III amp ) there are only two cables to run between
the two tx en out key in out . and then use the switch on the amp in qsk
mode . then go to the tx menu and enable loop 1 . is this correct am I
missing a hookup ? thanks John kb2huk
----- Original Message -----
From: "aa4nn" <aa4nn@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 9:14 AM
Subject: Re: [TenTec] having problem getting amp to work with Orion II
> Does the term QSK or PTT ring a bell?
> de Joe, aa4nn
> Lake Wylie, SC
> ------------------------------------------------------
>>> Hello all , I am having a problem getting my Orion II to work with my
>>> Titan III
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|