That is correct John!
73 John W4II
----- Original Message -----
From: "John Molenda" <brazos@rochester.rr.com>
To: "aa4nn" <aa4nn@earthlink.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Monday, March 22, 2010 5:19 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II
>I have reread the manual and looked at the hookup my question is this (when
> hooking Orion II to titan III amp ) there are only two cables to run
> between
> the two tx en out key in out . and then use the switch on the amp in qsk
> mode . then go to the tx menu and enable loop 1 . is this correct am I
> missing a hookup ? thanks John kb2huk
> ----- Original Message -----
> From: "aa4nn" <aa4nn@earthlink.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, March 22, 2010 9:14 AM
> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>
>
>> Does the term QSK or PTT ring a bell?
>> de Joe, aa4nn
>> Lake Wylie, SC
>> ------------------------------------------------------
>>>> Hello all , I am having a problem getting my Orion II to work with my
>>>> Titan III
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2763 - Release Date: 03/22/10
07:33:00
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|