TenTec
[Top] [All Lists]

Re: [TenTec] ORION II TX gone

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] ORION II TX gone
From: <n4py@arrl.net>
Reply-to: n4py@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 31 Jul 2008 07:56:57 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
My bet is the battery reset will fix it.  I have had this problem and the 
battery reset fixed it.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Tõnno Vähk" <Tonno.Vahk@gildbankers.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, July 31, 2008 2:43 AM
Subject: Re: [TenTec] ORION II TX gone


> yes, thanks. Keying loops are off and transmitter is ON. I do have the rig 
> going into TX and showing also 1.0 SWR all the time! Also the pot 
> indicator shows power but the meter does not and also nothing is going out 
> by external wattmeter. It shows 1.0 SWR also to empty antenna port. Thus 
> switching from ANT 1 to ANT 2 does not help.
>
> I will try the recommended battery reset and will also check if the PS 
> current goes up at TX (I am quite sure it does not...).
>
> I wonder how those guys solved it who have had this issue before?
>
> 73
> es5tv
>
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com] 
> On Behalf Of Barry N1EU
> Sent: Thursday, July 31, 2008 12:20 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] ORION II TX gone
>
> Do you have the keying loops turned off and the Transmitter turned on
> in the TX Menu?
>
> 73,
> Barry N1EU
>
> On Wed, Jul 30, 2008 at 8:06 PM, Tõnno Vähk <Tonno.Vahk@gildbankers.com> 
> wrote:
>> Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but 
>> no TX out in any mode, everything else seems normal. RX seems to be OK. I 
>> saw some messages in archives looking for solution to the same issue but 
>> no cure. Tried Master reset and also reinstalled firmware, no change. Is 
>> there anything I can try or should I send it to repairs?? Has it been 
>> established what the problem is?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>