yes, thanks. Keying loops are off and transmitter is ON. I do have the rig
going into TX and showing also 1.0 SWR all the time! Also the pot indicator
shows power but the meter does not and also nothing is going out by external
wattmeter. It shows 1.0 SWR also to empty antenna port. Thus switching from ANT
1 to ANT 2 does not help.
I will try the recommended battery reset and will also check if the PS current
goes up at TX (I am quite sure it does not...).
I wonder how those guys solved it who have had this issue before?
73
es5tv
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com] On
Behalf Of Barry N1EU
Sent: Thursday, July 31, 2008 12:20 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] ORION II TX gone
Do you have the keying loops turned off and the Transmitter turned on
in the TX Menu?
73,
Barry N1EU
On Wed, Jul 30, 2008 at 8:06 PM, Tõnno Vähk <Tonno.Vahk@gildbankers.com> wrote:
> Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but no
> TX out in any mode, everything else seems normal. RX seems to be OK. I saw
> some messages in archives looking for solution to the same issue but no cure.
> Tried Master reset and also reinstalled firmware, no change. Is there
> anything I can try or should I send it to repairs?? Has it been established
> what the problem is?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|