| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] ORION II TX gone |
| From: | Tõnno Vähk <Tonno.Vahk@gildbankers.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 30 Jul 2008 23:06:53 +0300 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but no TX out in any mode, everything else seems normal. RX seems to be OK. I saw some messages in archives looking for solution to the same issue but no cure. Tried Master reset and also reinstalled firmware, no change. Is there anything I can try or should I send it to repairs?? Has it been established what the problem is? 73 tonno es5tv _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Fwd: OMNI VII ESD Revisited, Bill Mellema |
|---|---|
| Next by Date: | Re: [TenTec] ORION II TX gone, n4py |
| Previous by Thread: | [TenTec] Fwd: OMNI VII ESD Revisited, Bill Mellema |
| Next by Thread: | Re: [TenTec] ORION II TX gone, n4py |
| Indexes: | [Date] [Thread] [Top] [All Lists] |