Guys:
If anyone would like a PDF of the cable wiring email me off the
reflector and I will get it to you. It helped me a lot.
73's
Bill N3WM
>Date: Wed, 30 Jul 2008 10:46:34 -0400
>To: Ten Tech Reflector
>From: Bill Mellema <mellema@qis.net>
>Subject: OMNI VII ESD Revisited
>Cc: "Jack Burchfield" <jburchfield@tentec.com>
>
>I rewired my D104 Mic with a 8 Pin cable I got from TT..the ESD
>issue has gone away. Pin 5 on the O7 is chassis ground and is the
>pin to use for PTT common and Mic audio shield. The cable has two
>wires within the shield for Mic - and Mic +.. I didn't realize the
>connectors on the front of the 07 are not connected to chassis
>ground. When Jack Burchfield of TT explained this to me the ESD
>solution became much clearer. Now the ESD bleeds to the chassis
>ground via Pin 5.
>
>
>
>73's
>
>Bill N3WM
>
>Bill Mellema
>B&J Communications Inc.
>2230 Ridgemont Drive
>Finksburg, Maryland 21048
>410-861-8199
>Fax 410-861-8605
>Cell 410-790-6072
Bill Mellema
B&J Communications Inc.
2230 Ridgemont Drive
Finksburg, Maryland 21048
410-861-8199
Fax 410-861-8605
Cell 410-790-6072
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|