Do you have the keying loops turned off and the Transmitter turned on
in the TX Menu?
73,
Barry N1EU
On Wed, Jul 30, 2008 at 8:06 PM, Tõnno Vähk <Tonno.Vahk@gildbankers.com> wrote:
> Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but no
> TX out in any mode, everything else seems normal. RX seems to be OK. I saw
> some messages in archives looking for solution to the same issue but no cure.
> Tried Master reset and also reinstalled firmware, no change. Is there
> anything I can try or should I send it to repairs?? Has it been established
> what the problem is?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|