the serial number on the supply is XTPN1110B
Thats all I have. Again, appreciate all the information.
scott VA3IED
----- Original Message -----
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, February 06, 2008 11:37 PM
Subject: Re: [TenTec] Omni V Maximum voltage
> It is not a regulated supply. There is a 12V output for the receiver and
> the control deck but the transmitter is FM and thus the ripple from the
> power supply has little effect on the transmitted signal.
>
> I'll get to the shop on Friday where the Micor ham repeaters, 3 of them,
> are located and where the manual resides. If you want specs drop me an
> e-mail direct.
>
> 73
> Bob K4TAX
>
>
> ----- Original Message -----
> From: <scottsheppard@videotron.ca>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, February 06, 2008 4:27 PM
> Subject: Re: [TenTec] Omni V Maximum voltage
>
>
>> Wow, quite the response. Most appreciated... I just cant see how motorola
>> would not have made a clean supply...it weighs about 35 lbs or more and
>> has at least 6 big canned capacitors and another smaller transformer...I
>> looked at the part/model number but very little info. The regulator board
>> has no adjustable pots...strange.
>>
>> Again thanks to all who helped...
>>
>> scott VA3IED
>>
>>
>>
>> ----- Original Message -----
>> From: Stuart Rohre <rohre@arlut.utexas.edu>
>> Date: Wednesday, February 6, 2008 4:40 pm
>> Subject: Re: [TenTec] Omni V Maximum voltage
>> To: Rick Denney <rwd@iteris.com>, Discussion of Ten-Tec Equipment
>> <tentec@contesting.com>
>>
>>> An old time repeater and two way guy I know is going to check
>>> his records,
>>> but he said to make sure the Micor is not a magnetically
>>> regulated
>>> transformer. IF it is, it would have a capacitor of high
>>> voltage across the
>>> transformer winding.
>>>
>>> Certainly the diodes in series will work; the bucking filament
>>> transformer
>>> might work. You would use half of the center tapped 6.3 VAC
>>> transformer in
>>> series with the primary of the Micor, and its primary on the AC
>>> line. The
>>> current rating must be equal or greater than the primary current
>>> of the
>>> Micor.
>>>
>>> -Stuart
>>> K5KVH
>>>
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|