TenTec
[Top] [All Lists]

Re: [TenTec] Omni V Maximum voltage

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni V Maximum voltage
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 6 Feb 2008 22:37:27 -0600
List-post: <mailto:tentec@contesting.com>
It is not a regulated supply.  There is a 12V output for the receiver and 
the control deck but the transmitter is FM and thus the ripple from the 
power supply has little effect on the transmitted signal.

I'll get to the shop on Friday where the Micor ham repeaters, 3 of them, 
are located and where the manual resides.  If you want specs drop me an 
e-mail direct.

73
Bob K4TAX


----- Original Message ----- 
From: <scottsheppard@videotron.ca>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, February 06, 2008 4:27 PM
Subject: Re: [TenTec] Omni V Maximum voltage


> Wow, quite the response. Most appreciated... I just cant see how motorola 
> would not have made a clean supply...it weighs about 35 lbs or more and 
> has at least 6 big canned capacitors and another smaller transformer...I 
> looked at the part/model number but very little info. The regulator board 
> has no adjustable pots...strange.
>
> Again thanks to all who helped...
>
> scott  VA3IED
>
>
>
> ----- Original Message -----
> From: Stuart Rohre <rohre@arlut.utexas.edu>
> Date: Wednesday, February 6, 2008 4:40 pm
> Subject: Re: [TenTec] Omni V Maximum voltage
> To: Rick Denney <rwd@iteris.com>, Discussion of Ten-Tec Equipment 
> <tentec@contesting.com>
>
>> An old time repeater and two way guy I know is going to check
>> his records,
>> but he said to make sure the Micor is not a magnetically
>> regulated
>> transformer. IF it is, it would have a capacitor of high
>> voltage across the
>> transformer winding.
>>
>> Certainly the diodes in series will work; the bucking filament
>> transformer
>> might work. You would use half of the center tapped 6.3 VAC
>> transformer in
>> series with the primary of the Micor, and its primary on the AC
>> line. The
>> current rating must be equal or greater than the primary current
>> of the
>> Micor.
>>
>> -Stuart
>> K5KVH
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>