My N4PY software for the Argonaut V will key the ArgoV without any keying
interface. It just sends software commands to the radio to key it. The
program also has a built in CW keyboard. See my webapge at www.n4py.com.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "designer" <designer@quickdata.com>
To: <tentec@contesting.com>
Sent: Monday, May 24, 2004 1:28 AM
Subject: Re: [TenTec] computer CW my Argonaut V???
> CWType, from DxSoft, is free. It uses a small circuit - two diodes,
> two resistors, one transistor (all available at Radio Shack) - to key
> the rig. Your cable goes from the serial port to the key jack - via
> the circuit. The five components will fit INSIDE the Radio Shack
> serial port plug assembly.
>
> Configuring the software might be a little tricky - but many have had
> success and there is a DxSoft support group on yahoo. You can create
> pre-set strings of code - like your CQ sequence or an initial
> name/QTH/rig/power/antenna/etc. stream
>
> The matching receiving software, CWGet, is not free.
> 73,
> Paul
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|