CWType, from DxSoft, is free. It uses a small circuit - two diodes,
two resistors, one transistor (all available at Radio Shack) - to key
the rig. Your cable goes from the serial port to the key jack - via
the circuit. The five components will fit INSIDE the Radio Shack
serial port plug assembly.
Configuring the software might be a little tricky - but many have had
success and there is a DxSoft support group on yahoo. You can create
pre-set strings of code - like your CQ sequence or an initial
name/QTH/rig/power/antenna/etc. stream
The matching receiving software, CWGet, is not free.
73,
Paul
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|