You're right! It's just that the instructions at the bottom of the
screen say only:
"Press ex function key to program <F3-F12, AltF1-AltF12, or ESCAPE to
exit>:"
This is different from the CQ instructions which way,
"Press CQ function key to program <F1, AltF1, CtrlF1>, or ESCAPE to
exit."
-----Original Message-----
From: J. Edward (Ed) Muns [mailto:w0yk@msn.com]
Sent: Thursday, December 05, 2002 11:38 AM
To: Robert Brandon; 'TRLog Reflector'
Subject: RE: [TRLog] Why no Ctrl-Fx keys in exchange mode?
Ctrl-F keys are already available in Exchange mode. It is documented in
manual 6.63, page 140, and I use them all the time.
73,
Ed - W0YK
> -----Original Message-----
> From: trlog-admin@contesting.com [mailto:trlog-admin@contesting.com]On
> Behalf Of Robert Brandon
> Sent: Thursday, December 05, 2002 8:58 AM
> To: 'TRLog Reflector'
> Subject: [TRLog] Why no Ctrl-Fx keys in exchange mode?
>
>
> In CQ mode, there are three sets of programmable keys -- plain F1-F10,
> Alt-F1-F10, and Ctrl-F1-F10. In exchange mode, however, only plain F
> keys and Alt-F keys are available. I had in mind to set up Ctrl-F
keys
> for second radio fills, etc.. Would it be possible to add Ctrl-F keys
> in exchange mode?
>
> Robert K5PI
>
> -----Original Message-----
> From: trlog-admin@contesting.com [mailto:trlog-admin@contesting.com]
On
> Behalf Of Mike Gilmer, N2MG
> Sent: Thursday, December 05, 2002 6:26 AM
> To: U.Lautenbach@OLG-Senate-Kassel.Justiz.Hessen.de
> Cc: TRLog Reflector
> Subject: Re: Antwort: Re: [TRLog] Why?
>
> N2MG wrote:
> > > Also, some of the CW messages (F1 and F2 in exchange) are not
> > > accessible/editable from ALT-P - only in the cfg file. Why is
that?
>
> DL2ZAZ wrote:
> > They are accessed by Alt-P O because they can also be sent by the
> enter
> > key.
>
> OK, I do see why F1 on ALT-P E is like it is (it's "MYCALL" and should
> be
> setup in cfg and probably NOT changed mid-contest) Also, F2 has two
> settings, so allowing access on that page might be ugly. However since
> both
> F2 choices ARE accessible via ALT-P O it should SAY this on the ALT-P
E
> page - there IS enough room. The way the ALT-P E page is laid out it
> looks
> like both F2 and F1 are only available in the cfg. I realize this can
> be
> "learned" but it would make it easier for new TR users.
>
> Mike N2MG
>
>
> _______________________________________________
> TRLog mailing list
> TRLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
>
> _______________________________________________
> TRLog mailing list
> TRLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
|