Folks,
There is a caveat to using the CTRL-Fx keys when running phone mode. In both
CQ and S&P modes if DVP is enabled OR a DVK port is assigned, then CTRL-Fx is
the shortcut to program a DVP message on the fly. The keys are available to
program at all times, but will not be accessible under the above conditions.
--
73 es God Bless de KK1L...ron rossi(kk1l@arrl.net) <><
Support Programmer for TRLog http://www.qth.com/tr
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l
>Ctrl-F keys are already available in Exchange mode. It is documented in
>manual 6.63, page 140, and I use them all the time.
>
>73,
>Ed - W0YK
>
>
>> -----Original Message-----
>> From: trlog-admin@contesting.com [mailto:trlog-admin@contesting.com]On
>> Behalf Of Robert Brandon
>> Sent: Thursday, December 05, 2002 8:58 AM
>> To: 'TRLog Reflector'
>> Subject: [TRLog] Why no Ctrl-Fx keys in exchange mode?
>>
>>
>> In CQ mode, there are three sets of programmable keys -- plain F1-F10,
>> Alt-F1-F10, and Ctrl-F1-F10. In exchange mode, however, only plain F
>> keys and Alt-F keys are available. I had in mind to set up Ctrl-F keys
>> for second radio fills, etc.. Would it be possible to add Ctrl-F keys
>> in exchange mode?
>>
>> Robert K5PI
>>
>> -----Original Message-----
>> From: trlog-admin@contesting.com [mailto:trlog-admin@contesting.com] On
>> Behalf Of Mike Gilmer, N2MG
>> Sent: Thursday, December 05, 2002 6:26 AM
>> To: U.Lautenbach@OLG-Senate-Kassel.Justiz.Hessen.de
>> Cc: TRLog Reflector
>> Subject: Re: Antwort: Re: [TRLog] Why?
>>
>> N2MG wrote:
>> > > Also, some of the CW messages (F1 and F2 in exchange) are not
>> > > accessible/editable from ALT-P - only in the cfg file. Why is that?
>>
>> DL2ZAZ wrote:
>> > They are accessed by Alt-P O because they can also be sent by the
>> enter
>> > key.
>>
>> OK, I do see why F1 on ALT-P E is like it is (it's "MYCALL" and should
>> be
>> setup in cfg and probably NOT changed mid-contest) Also, F2 has two
>> settings, so allowing access on that page might be ugly. However since
>> both
>> F2 choices ARE accessible via ALT-P O it should SAY this on the ALT-P E
>> page - there IS enough room. The way the ALT-P E page is laid out it
>> looks
>> like both F2 and F1 are only available in the cfg. I realize this can
>> be
>> "learned" but it would make it easier for new TR users.
>>
>> Mike N2MG
>>
>>
>> _______________________________________________
>> TRLog mailing list
>> TRLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/trlog
>>
>>
>> _______________________________________________
>> TRLog mailing list
>> TRLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/trlog
>>
>
>_______________________________________________
>TRLog mailing list
>TRLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/trlog
|