In CQ mode, there are three sets of programmable keys -- plain F1-F10,
Alt-F1-F10, and Ctrl-F1-F10. In exchange mode, however, only plain F
keys and Alt-F keys are available. I had in mind to set up Ctrl-F keys
for second radio fills, etc.. Would it be possible to add Ctrl-F keys
in exchange mode?
Robert K5PI
-----Original Message-----
From: trlog-admin@contesting.com [mailto:trlog-admin@contesting.com] On
Behalf Of Mike Gilmer, N2MG
Sent: Thursday, December 05, 2002 6:26 AM
To: U.Lautenbach@OLG-Senate-Kassel.Justiz.Hessen.de
Cc: TRLog Reflector
Subject: Re: Antwort: Re: [TRLog] Why?
N2MG wrote:
> > Also, some of the CW messages (F1 and F2 in exchange) are not
> > accessible/editable from ALT-P - only in the cfg file. Why is that?
DL2ZAZ wrote:
> They are accessed by Alt-P O because they can also be sent by the
enter
> key.
OK, I do see why F1 on ALT-P E is like it is (it's "MYCALL" and should
be
setup in cfg and probably NOT changed mid-contest) Also, F2 has two
settings, so allowing access on that page might be ugly. However since
both
F2 choices ARE accessible via ALT-P O it should SAY this on the ALT-P E
page - there IS enough room. The way the ALT-P E page is laid out it
looks
like both F2 and F1 are only available in the cfg. I realize this can
be
"learned" but it would make it easier for new TR users.
Mike N2MG
_______________________________________________
TRLog mailing list
TRLog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|