TenTec
[Top] [All Lists]

Re: [TenTec] Corsair II realignment: DIY?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Corsair II realignment: DIY?
From: Joe Roberts <jroberts@io.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 01 Jan 2011 18:15:49 -0500
List-post: <mailto:tentec@contesting.com>
Check out this list.

http://www.nichicon.co.jp/english/products/alm_mini/list_f.htm

You can find a lot of these "P" series Nichicons on ebay in lots for cheap. Try to spot the date codes in the pics.

Also Sanyo Os-Con solid caps are good and "motherboard" caps (for large value PS caps).

105 degree rating is a good marker, then look them up.

Joe N5KAT



On 1/1/2011 6:07 PM, Dr. Gerald N. Johnson wrote:
Mouser Xicon ESRL series. Maybe Nichicon UPW series which is also
carried by Digi-Key.

73, Jerry, K0CQ

On 1/1/2011 4:46 PM, Al Gulseth wrote:
Jerry,

Can you give some specifics as to recommended mfg. and part series for said
caps (from Mouser/DigiKey etc.)? I have several vintage TTs that could
probably use that treatment....

TNX/73, Al

On Sat January 1 2011 2:00:14 pm tentec-request@contesting.com wrote:
Miniature electrolytics are ripe for replacement due to old age. Go for
low ESR high temperature rated for the best performance and long life.
Don't forget those on the display board.<

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



<Prev in Thread] Current Thread [Next in Thread>