I'm pretty sure those rigs have a Notch control. Those are very prone to
getting dirty and shutting down the audio. Wiggling the Notch pot will cure
the trouble until next time if that is what's causing it.
73, Mike N4NT
----- Original Message -----
From: "John Graves" <jh.graves@verizon.net>
To: <tentec@contesting.com>
Sent: Thursday, November 18, 2010 2:22 PM
Subject: [TenTec] Argosy
> My Argosy has developed an annoying problem. The audio level (I think)
> goes to or approaches zero. If I repower, audio returns to normal until
> it happens again. As I am using it primarily for QRP and running 5
> watts I don't know - can't tell if it is affecting output.
>
> I am open to suggestions regarding where I can start poking. It has
> both a standard 220 SSB crystal filter as well as the audio cw filter
> but the problem seems to occcur regardless if either or none of the
> filters are selected.
>
> --
> John -- WA1JG
>
> WA1JG@nsradio.org
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|