| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] paragon PLL error - Help me decide! |
| From: | Randy Hargenrader <k4qo@earthlink.net> |
| Reply-to: | k4qo@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 14 Jan 2008 14:45:56 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
My Paragon had that problem - its easy to fix by resoldering the PLL
modules. I didn't find it necessary to pull all the parts off, etc... I
just reflowed the solder and the problem hasn't been back since.
Mine had a bad solder joint due to temperature variations that
eventually allowed a part lead to pull loose from the solder blob on the
PCB. Re-flow fixed it.
73, Randy K4QO |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] What is this rig?, Geoffrey S. Mendelson |
|---|---|
| Next by Date: | Re: [TenTec] What is this rig?, Dr. Gerald N. Johnson |
| Previous by Thread: | Re: [TenTec] paragon PLL error - Help me decide!, k4beh@juno.com |
| Next by Thread: | Re: [TenTec] paragon PLL error - Help me decide!, DC |
| Indexes: | [Date] [Thread] [Top] [All Lists] |