Group,
I am working on an Omni D for a friend. The original complaint was low
output on 160 meters. I removed the RCA plug that goes into the final
amplifier module and put a scope on it (the output from the driver). All
levels look similar, but the 160 waveform looks dirty/distorted
(parasitic oscillation?) compared to the 80-10 waveforms.
It has been suggested that this could be due to an alignment issue.
Therefore, the following question: Could someone photocopy or scan the
alignment section from the manual and either e-mail or snail mail to me?
(Photocopy and postage costs reimbursed). Or, does someone have an Omni
D manual surplus to their needs they would be willing to sell?
Thanks and 73,
Carter K8VT
|