Group,
1) I should have been more clear that I was just looking for copies of a
few pages (on alignment), not the entire manual, which I understand is
quite large.
2) Thanks for the many kind offers to send the required info...
3) One of the (many) great folks on the reflector had the required info
already in digital form and emailed it.
So, I'm all set and a big thanks to all who responded!!!! Now, off to
the work bench. It may be a week or two, but I will try and let everyone
know how it worked out.
Thanks again and 73,
Carter
Carter, K8VT wrote:
Group,
I am working on an Omni D for a friend. The original complaint was
low output on 160 meters. I removed the RCA plug that goes into the
final amplifier module and put a scope on it (the output from the
driver). All levels look similar, but the 160 waveform looks
dirty/distorted (parasitic oscillation?) compared to the 80-10
waveforms.
It has been suggested that this could be due to an alignment issue.
Therefore, the following question: Could someone photocopy or scan
the alignment section from the manual and either e-mail or snail mail
to me? (Photocopy and postage costs reimbursed). Or, does someone
have an Omni D manual surplus to their needs they would be willing to
sell?
|