Did Yaesu mention which alignment these changes were to be set? I have a few
FT-1000MP MRK V's and there is a software setting for those...
But not sure where to set this on the FT-1000 series. Im assuming it's a
hardware setting.
Thanks..
-----Original Message-----
From: Robert Carroll [mailto:w2wg@comcast.net]
Sent: Monday, August 18, 2008 5:00 AM
To: Rich Hallman - N7TR
Subject: RE: [Yaesu] FT-1000 Alignment Question - SHIFT Control Center
I am not an expert on the subject but there are RX carrier injection point
settings for upper and lower sideband and TX carrier offset for USB and LSB.
Perhaps if you do not have symmetric settings in the TX points, you get
different sounding audio. I have recently been looking at a note Yaesu sent
me way back in 1996 saying that instead of the defaults of 0, the TX for USB
should be set to +100Hz and the TX for LSB should be set to -100Hz and that
this was related to SSB signal "punch." At the time there had been
complaints about the punch of the FT1000MP on SSB.
Related to this, I now have an FT-2000 and nite that though the RX offset
menu selections remain, there are no TX carrier injection point settings in
the menu. Can someone educate me on these settings? I assume they are set
and nto adjustable on the 2000 but I don't know for sure.
73
Bob W2WG
-----Original Message-----
From: yaesu-bounces@contesting.com [mailto:yaesu-bounces@contesting.com] On
Behalf Of Rich Hallman - N7TR
Sent: Sunday, August 17, 2008 7:19 PM
To: GGLL; yaesu@contesting.com
Subject: Re: [Yaesu] FT-1000 Alignment Question - SHIFT Control Center
I have not tested that but the monitor tx audio seems to sound the same
between both sidebands..
-----Original Message-----
From: yaesu-bounces@contesting.com [mailto:yaesu-bounces@contesting.com] On
Behalf Of GGLL
Sent: Sunday, August 17, 2008 2:46 PM
To: yaesu@contesting.com
Subject: Re: [Yaesu] FT-1000 Alignment Question - SHIFT Control Center
Do you get similar reports on your transmission?.
Regards
Guillermo - LU8EYW.
Rich Hallman - N7TR escribió:
> I noticed on one of my FT-1000's that the audio tone difference between
> USB and LSB is quite noticeable. To get the tone correct I need to turn
> the SHIFT control from center to almost 3 o'clock for one side...then 9
> o'clock for the other sideband.
>
>
>
> I have the alignment manual, but wanted to know what alignment would
> potentially fix this issue.
>
>
>
> Thanks...
>
> Rich
>
>
>
> Rich N7TR
>
> ex KI3V, N3AMK, WB3JOV
>
> www.n7tr.com
>
> Telnet: dxc.n7tr.com N7TR DXCluster
>
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
E-mail message checked by Spyware Doctor (5.5.1.322)
Database version: 5.10490e
http://www.pctools.com/en/spyware-doctor/
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|