Great question, and I've wondered the same myself since the turn of the century!
Save Configuration saves all parameters that are in the ini file. Those
parameters apply to all contests. If, for example, you change your Port
assignments, you have to do a Save Configuration for the changes to be in
effect next time you run WL.
The File...Save command saves the .wl contest log file. It contains all the
contest-specific parameters, like which windows are open, whether they're
docked or undocked, the exchange parameters and format, the CW/SSB messages,
etc., and of course the log entries, notes and so-forth.
Whie the window statuses (which one are open, docked/undocked) are in the .wl
file, the position and sizes of the windows are in the ini file. I'm not sure
exactly how WL deals with window statuses when you open a new log from the
startup window. It appears to use the window statuses from the previous
contest, but I don't know if it opens that contest file to get them or if
they're saved in the ini file and then overridden when you load an existing
contest file. And I think you have to do a Save Configuration to save the
window statuses from the current contest in order for them to be used when you
open a new contest file from the startup window. I think that's the way it
works because I can see a flash of the previous layout before the layout from
the contest file takes effect, and WL they previous layout isn't necessarily
the last contest file I had open. Anyway, I'd prefer to see the all window
status and display parameters stored in the contest file so I can tailor the
look for
each contest.
I *think* most of the settings under Setup... Document Settings are in the .wl
contest file, which most if not all of the Setup... Writelog Options settings
are in the ini file and apply to all contests.
It would be nice to have a list of exactly which settings are saved with Save
Configuration and File...Save, but I can't find one in the Help file. You can
make one by pulling down all the menus and checking each command for a
corresponding entry in the ini file, with those that are not in the ini file
being contest-specific. There are also parameters that are never saved and have
to be reconfigured when you restart WL, like the current CW speeds, which radio
logs the QSO, etc.
73, Dick WC1M
-----Original Message-----
From: Jeff Stai <wk6i.jeff@gmail.com>
Sent: Saturday, July 20, 2019 1:11 AM
To: Writelog Reflector <writelog@contesting.com>
Subject: [WriteLog] save configuration
I've been using writelog since the turn of the century I think. There are some
things I do, because back when I learned how to get writelog to do what I
wanted it to do - and not get burned or lose things - those things just seemed
to work. It's almost like a ritual or incantation.
One of these things is save configuration. When setting up for a contest I bet
I do a save configuration 100 times. Every time I set a parameter or enable
something it's:
Save File
Setup
choose Save Configuration
click OK.
...because I don't want to lose what I have done and start over.
I have questions.
1. Why is save configuration still a tedious three click task? Why isn't it a
one click button like file save?
2. I'm going to guess the answer. It's because save configuration is actually
something you almost never have to do so why make a button for it.
Right?
3. If that is the case, then I must be doing save configuration about 99 times
too much...?
4. So then, what does save configuration really do?
73 jeff wk6i
--
Jeff Stai ~ WK6I ~ wk6i.jeff@gmail.com
RTTY op at W7RN
Twisted Oak Winery ~ http://www.twistedoak.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|