Towertalk
[Top] [All Lists]

Re: [TowerTalk] Radial Attachment Plate

To: reflector Towertalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] Radial Attachment Plate
From: David Hachadorian <k6ll.dave@gmail.com>
Date: Mon, 30 Oct 2023 21:33:38 -0700
List-post: <mailto:towertalk@contesting.com>
Here's what I've been using for many years:
https://www.homedepot.com/p/Square-D-23-Terminal-Ground-Bar-Kit-for-QO-Homeline-Electrical-Panel-Load-Center-PK23GTACP-PK23GTACP/100129430

You could use two smaller ones, on different sides of the tower to make it neater.

Dave Hachadorian, K6LL
Yuma, AZ

On 10/30/2023 8:40 PM, john@kk9a.com wrote:
I had a DX Engineering radial plate on my P40A 160m vertical and had zero
corrosion.  You could cut one in half to go around the tower.

Rolling up multiple attached wires would likely become a tangles mess.

You should be able to find suitable stainless steel angle at Mc-Master Carr,
drilling a Ø5/8 hole is easy.  You could also drill multiple holes and bolt
the radials directly to the angle.
https://www.mcmaster.com/products/angles/material~stainless-steel-2/corrosio
n-resistant-316-stainless-steel-6/

John KK9A



Stan Stockton k5go wrote:

Jim,

Thanks for pointing me to that review.  I looked at that picture.  These
are 304 grade stainless. DX Engineering's plate is the same - 304 stainless
steel which is not the best for corrosion resistance.  316 would be much
better.  Those in the review were installed on a table 100 feet from the
sea with the crappy sheet metal screws included that will definitely
corrode.  Of course there is a huge difference between 75 or 100 feet and 5
miles from the salt water regarding corrosion.

My plan is to get all my radials attached and then perhaps spray the whole
thing with liquid electrical tape and deploy it when I am there for a few
months a year.  Then I will roll the radials up and store it intact when I
am not there, relying on however many radials I have buried during the off
season.

In my application I want it around a tower which this will do and the DX
Engineering plate will not.

There are several sizes and the smallest one which would be good for a
vertical made from aluminum tubing would only cost $7.99 delivered.  Can't
beat that deal.

What I need now is a stainless steel angle the right size and preferably
with a 5/8" hole to mount an SO-239 to the radial plate.

73...Stan

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>