In preparing to head to ZF9CW in about ten days, I wanted to take something
that would allow me to do a better job on my radials under my shunt fed
tower. With the thing so close to salt water the detriment is that
everything corrodes in a short period of time.
I was looking for something to help solve my problem and found this on
Amazon:
https://www.amazon.com/dp/B08N6X576D?psc=1&ref=ppx_yo2ov_dt_b_product_details
You can add however many you want to size a square or most any shape to
surround a vertical or tower. I will likely use 8 of them to make a square
to go around a 55G tower if I decide to use that one someday. In my case,
since I cannot run radials onto my neighbors property I will only use three
of them to go around my 25G tower. The holes are M6 size. I put together
four of these plates in a square and have stainless steel M6 hardware
installed in the 28 holes. Even for this small version you could have 3
radials to each connection point and have 84 radials.
If you are interested send me an email and I will send you a picture of the
thing put together.
I think it will help with my corrosion problem and wanted to share the
information.
73...Stan, K5GO/ZF9CW/ZF5T
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|