Jim,
Thanks for pointing me to that review. I looked at that picture. These
are 304 grade stainless. DX Engineering's plate is the same - 304 stainless
steel which is not the best for corrosion resistance. 316 would be much
better. Those in the review were installed on a table 100 feet from the
sea with the crappy sheet metal screws included that will definitely
corrode. Of course there is a huge difference between 75 or 100 feet and 5
miles from the salt water regarding corrosion.
My plan is to get all my radials attached and then perhaps spray the whole
thing with liquid electrical tape and deploy it when I am there for a few
months a year. Then I will roll the radials up and store it intact when I
am not there, relying on however many radials I have buried during the off
season.
In my application I want it around a tower which this will do and the DX
Engineering plate will not.
There are several sizes and the smallest one which would be good for a
vertical made from aluminum tubing would only cost $7.99 delivered. Can't
beat that deal.
What I need now is a stainless steel angle the right size and preferably
with a 5/8" hole to mount an SO-239 to the radial plate.
73...Stan
On Mon, Oct 30, 2023 at 5:53 PM Jim Brown<jim@audiosystemsgroup.com> wrote:
On 10/30/2023 3:25 PM, Stan Stockton wrote:
If you are interested send me an email and I will send you a picture of
the
thing put together.
I think it will help with my corrosion problem and wanted to share the
information.
A caution, Stan. One of the reviews notes corrosion after six months.
I'm using the DX Eng radial plate. Pricy, but 17 years later, not a
sniff of corrosion, 5 miles from the Pacific.
73, Jim K9YC
_________________
Searchable Archives:http://www.contesting.com/_topband - Topband
Reflector
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk