On 2/5/2023 8:18 PM, Lux, Jim wrote:
I just do a cal with the coax, putting the O,S,L at the end. Then
between that measurement, and the no coax cal, you've got the S21 for
the Coax, which most of the tools will de-embed if needed. You could
probably just do a "open" measurement and it would be good enough to
measure the coax.
I guess if you've got an antenna up on the tower, that's a bit harder.
The only antennas I can access to do that are RX antennas and 160M
verticals.
(although I suspect someone could come up with a scheme where you look
"off resonance" where the antenna impedance is wildly off resonance, and
then interpolate)
As you probably know, it's easy to get good TDR data with an antenna
connected, whether some form of impulse or inverse FFT of swept
impedance. An impulse is inherently broadband, and because a very wide
sweep is required for decent distance resolution, nearly all practical
antennas are resonant over a small fraction of the wide sweep, there
will be a strong reflection at all frequencies where the antenna is not
resonant. I typically sweep 50-550 MHz so as to avoid the part of the
spectrum where VF is most variable.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|