I’d try Send Cut Send. They are fast and reasonably priced.
Bill Putney
Chief Engineer - KPTZ
El Jefe de Contenido - Port Townsend Film Festival
Private Pilot-Single Engine Land | Airframe & Powerplant / Inspection
Authorization
> On Mar 25, 2022, at 12:06 PM, john@kk9a.com wrote:
>
> Perhaps K7PN or K0XG can make those components for you. I worked in
> manufacturing so I was able to make the plates for my Rohn 65 tower myself.
> If you can draw them with a CAD system it should not be difficult to find a
> local place with a laser or water jet to cut out the plates. Getting them
> galvanized is easy.
>
> GL,
> John KK9A - PJ4R this weekend.
>
>
>
> Byron W5FH wrote:
>
> Anyone know where to obtain rotor and bearing shelves for the 65G
> tower?Thanks, Byron W5FH
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|