Re: [TowerTalk] Rohn 65G Accessories

[Grant Saviers <grants2@pacbell.net>]

I couldn't find them commercially, so had my design waterjet cut from 
1/4" A36 plate and hot dip galvanized.  Plasma or laser cutting would 
also work fine and likely be cheaper.
Grant KZ1W

On 3/23/2022 20:14, Byron Tatum wrote:
> Anyone know where to obtain rotor and bearing shelves for the 65G tower?Thanks, 
> Byron W5FH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk