On 10/18/21 6:05 PM, Michael Tope wrote:
Hi John,
Yes, I understand about the lack of shields on most rotator cables.
That is in part what prompted my question. It seems like the rotator
cable is "the elephant in the room" when it comes to grounding and
bonding. When you consider the cost of a rotator, especially some of
the larger ones designed to turn large HF arrays, it seems like it
would be something important to address.
By the way, what has your experience been with the reliability of
having MOVs up on your tower(s)? I am asking in part because I am
helping with an installation that sits on a high ridge where the
rotator is controlled via 1700ft of heavy duty control cable (multiple
12 AWG conductors), which in this particular case, happens to be
shielded. I am trying to decide whether bonding the shield at the base
of the tower and up at the rotator will be sufficient, or whether
adding some transient protection at the rotator and/or the tower base
is warranted. Climbing the tower is a PITA, so I don't want to include
transient suppressors that need frequent replacement (facility rules
require that we hire a professional tower climber to service anything
on the tower that can't be reached from the ground).
Exactly - say you put your transient suppressors in a box at the base of
the tower.
BTW a good reason to not use MOVs, since they "wear out".
the motor is probably good for several kV overvoltage - even if you
punch a hole in the insulation from a transient, if it's running at
normal voltages, it doesn't cause a problem. I had a problem with some
5 and 10HP motors run off electronic variable speed drives. There's an
issue with these drives (of some vintages, 20+ years ago) where there
can be transients. That punches through the insulation - the motor runs
fine, but it trips the ground fault protection.
73, Mike W4EF.............
What has your experience been with MOV reliability?
On 10/15/2021 8:05 AM, john@kk9a.com wrote:
Rotator cables typically have no shield to bond to the tower. I use MOVs
near all of my rotators to protect the motors and potentiometers.
John KK9A
Michael Tope W4EF wrote:
Jim, et al:
What about control cables coming down the tower? I just skimmed through
the first edition of Ward's grounding book. It recommends bonding the
coax shields to the tower, but doesn't say anything about control
cables. Typically there is a least one rotator control cable in the mix
and oftentimes additional control cables for array switches and multiple
Tic ring rotators on larger more sophisticated installations. That seems
like an inconsistency, no?
73, Mike W4EF...........
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|